Hi guys.
I’m after some help in the internal settings of Adobe Audition 3.0 whilst I’m trying to run my condenser mic through my ART USB Dual Pre.
I have the USB Dual Pre all set up in my Windows 7 set up (it automatically becomes the default recording device when it’s plugged in), phantom power enabled, XLR cable plugged into the right socket of the two available (is there any difference? I’m just recording voice tracking for radio announcements), headphones plugged into the monitoring jack at the back. Levels are turned up enough that they will pick up the noise, if there was any.
I go to the “edit” tab in Adobe Audition 3.0, hit record and nothing comes up. I’m not getting any sound at all registered on the computer. I’ve downloaded and installed Asio4All, but can’t for the life of me figure out the configuration within the “Edit > Audio Hardware Setup” to make the damn thing pick up my voice. There’s mention of Audio Drivers (Asio4All or Audition 3.0 Windows Sound), USB Audio Codecs, Input/Output… it’s enough to make a man who’s not very good at this sort of thing cry (ie. Me).
Could anybody help a body out, please? I think I’ve done everything right except the configuration within Audition itself. A helping hand would be GREATLY appreciated.
Thanks so much!